SmartFusion Modules > Payroll > Maintenance > Set/Reset Salaries

Recent Change:  
6.231 
- Fixed the issue where the pay rate set/reset did not work on any pay type that has a ratio above 1.0 only for the hourly employees. 

6.220 
- Pay Type radio buttons will now correctly filter employees by Salary/Hourly/All.
- Corrected issue where Overtime pay types were not being updated properly.

6.078 - Added a flat rate option when just looking at hourly pay.

6.064 - Fixed the issue where it was not updating Fields on Salary Accounts Tab correctly when they choose to set salaries with the round pay rate option checked.

Introduction

This option allows the user to set/increase or reset the salaries of employees by a certain percentage or flat rate for hourly. This option would work successfully only if the " Allow override standard amounts on salary accounts tab when annual wages updated" is checked in the Payroll System File on Page 3. If not checked the set/reset salaries would not work on all employees.

Explanation

Input Criteria -

• PayType - Salary, Hourly, or Both (which covers all pay types in general)
• Factor to be used - Percentage by which the salaries are to be set/reset ( A factor of 5% would be entered as 1.05)
• Percentage or Flat - The rate of change to change pay by. Flat is only available when updating just the hourly employees.
• Employee Status - The user can choose to run for a particular employee status ( Full Time, Part Time, Retiree, Temporary). If left blank all employees will be considered regardless of the Status.
• Set/ Reset - User can choose either the set or the reset option
• Round Pay Rate - User can choose this option if they need the pay rate to be rounded to 2 digits ( Otherwise it is rounded to 4 digits)

Include All Criteria

• Classes
• Locations
• Departments
• Employees
• Pay Group